D-Link xStack DES-3500 Series Manual page 120

config gvrp
Restrictions
Example usage:
To set the ingress checking status, the sending and receiving GVRP information:
DES-3526:admin#config gvrp 1-4 state enable
ingress_checking enable acceptable_frame tagged_only pvid
2
Command: config gvrp 1-4 state enable ingress_checking
enable acceptable_frame tagged_only pvid 2
Success.
DES-3526:admin#
enable gvrp
Purpose
Syntax
Description
Parameters
Restrictions
Example usage:
To enable the generic VLAN Registration Protocol (GVRP):
DES-3526:admin#enable gvrp
Command: enable gvrp
Success.
DES-3526:admin#
disable gvrp
Purpose
Syntax
Description
Parameters
Restrictions
DES-3500 Layer 2 Fast Ethernet Switch CLI Reference Manual
checking for the specified port list.
acceptable_frame [tagged_only | admit_all] – This parameter states
the frame type that will be accepted by the Switch for this function.
tagged_only implies that only VLAN tagged frames will be accepted,
while admit_all implies tagged and untagged frames will be accepted
by the Switch.
pvid <vlanid 1-4094> – Specifies the default VLAN associated with
the port.
User Account Command Level – Administrator and Operator.
Used to enable GVRP on the Switch.
enable gvrp
This command, along with disable gvrp below, is used to enable and
disable GVRP on the Switch, without changing the GVRP configuration
on the Switch.
None.
User Account Command Level – Administrator and Operator.
Used to disable GVRP on the Switch.
disable gvrp
This command, along with enable gvrp, is used to enable and
disable GVRP on the Switch, without changing the GVRP
configuration on the Switch.
None.
User Account Command Level – Administrator and Operator.
116