D-Link xStack DES-3500 Series Manual page 205

DES-3526:admin#show flow_meter
Command: show flow_meter
Flow Metering Information
Profile Id
----------
1
Total Entries : 1
DES-3526:admin#
show current_config access_profile
Purpose
Syntax
Description
Parameters
Restrictions
Example usage:
To show the current config access profile on the Switch:
DES-3526:admin# show current_config access_profile
Command: show current_config access_profile
#----------------------------------------------------------------
# ACL
create access_profile ethernet vlan profile_id 1
config access_profile profile_id 1 add access_id 1 ethernet vlan
default port 1
permit
disable cpu_interface_filtering
#----------------------------------------------------------------
DES-3526:admin#
config time_range
Purpose
Syntax
Description
Parameters
DES-3500 Layer 2 Fast Ethernet Switch CLI Reference Manual
Access Id Metering Rate(Kbps)
--------- -------------------
1
Used to show the ACL CLI commands in current configuration.
show current_config access_profile
The ACL part will be displayed by this command.
None
None
Used to configure the range of time to activate a function on the switch.
<range_name 32> [ hours start_time < hh:mm:ss > end_time<
hh:mm:ss > weekdays <daylist> | delete]
This command defines a specific range of time to activate a function on the
Switch by specifying which time range in a day and which days in a week
are covered in the time range. Note that the specified time range is based
on SNTP time or configured time. If this time is not available, then the time
range will not be met. There are a maximum of 64 entries.
range_name - Specifies the name of the time range settings.
1000
201
Rate Exceed Action
-------------------
drop_packet