Setup And Configuration Overview; Configuring The Nas 1000S - HP StorageWorks NAS 1000s Quick Start Manual

Setup and Configuration Overview

Setting up systems is a well-defined process. This section is
intended as an overview of the process, not a detailed list of
step-by-step instructions. Step-by-step procedures are
documented in the administration guide. Some of the steps are
driven by wizards within the WebUI. In either type of setup, it is
important to read all of the supplied documentation before
starting. Relevant documents include:
■ HP StorageWorks NAS 1000s Administration Guide
■ HP StorageWorks NAS 1000s Rack Installation Instructions
HP StorageWorks NAS 1000s Release Notes (if required, this
■
document will be available via www.hp.com)

Configuring the NAS 1000s

The following describes how to configure the NAS 1000s.
1. Configure the NAS device using Chapter 2 of this guide.
2. This is a recommended step. Place the NAS device into an
Active Directory or Windows NT 4.0 domain for ease of
manageability.
3. Configure the NAS 1000s device using Chapter 3 of this
guide.
4. Using Logical Disk Manager (LDM), assign drive letters or
mount points, and format the data drives. See the LDM online
help for full details on this procedure.
5. This is an optional step. Enable protocols such as NFS
sharing, NCP, and/or AppleTalk. See the administration guide
for this procedure in detail.
6. This is an optional step. Create shares corresponding to the
protocols mentioned in the previous steps. Grant access rights
to the shares.
7. Read the remaining sections of the administration guide.
22 NAS 1000s Quick Start Guide