Show Lldp Med Remote-Device; Show Lldp Med Remote-Device Detail - NETGEAR GSM7248R Command Line Interface Reference Manual

Command Line Interface Reference for the ProSafe 7200RS Series Layer-2 Stackable Switches

17.2.12 show lldp med remote-device

This command displays summary information about remote devices that transmit
current LLDP MED data to the system. You can show information about LLDP
remote data received on all ports or on a specific port.
Format
Mode
Interface
Device Class

17.2.13 show lldp med remote-device detail

This command displays display detailed information about remote devices that
transmit current LLDP MED data to an interface on the system.
Format
Mode
Supported
Capabilities
Enabled
Capabilities
Device Class
Network Policy
Information
LLDP and LLDP-MED Commands
show lldp med remote-device [<unit/slot/port> | all ]
Privileged EXEC
The interface in a unit/slot/port format.
The Remote device's MED Classification. There are four dif-
ferent kinds of devices, three of them represent the actual end
points (classified as Class I Generic [IP Communication Con-
troller etc.], Class II Media [Conference Bridge etc.], Class
III Communication [IP Telephone etc]). The fourth device is
Network Connectivity Device, which is typically a LAN
Switch/Router, IEEE 802.1 Bridge, IEEE 802.11 Wireless
Access Point etc.
show lldp med remote-device detail [<unit/slot/port> ]
Privileged EXEC
Shows the supported capabilities that was received in MED
TLV on this port.
Shows the enabled capabilities that was enabled in MED
TLV on this port.
Shows the device class as advertised by the device remotely
connected to the port.
Shows if network policy TLV is received in the LLDP frames
on this prot.
v1.0, October 2008
17-13