Storm-Control Broadcast; Storm-Control Multicast - NETGEAR GSM7248R Command Line Interface Reference Manual

Command Line Interface Reference for the ProSafe 7200RS Series Layer-2 Stackable Switches
9.2.3.1 no storm-control unicast all
This command disables multicast storm recovery mode.
Format
Mode

9.2.4 storm-control broadcast

This command enables broadcast storm recovery mode in per-port level. If the mode is
enabled, broadcast storm recovery with high and low thresholds is implemented. The
<level> value is in a range of 0 to 100 (in percentage). A value of 0 means no storm
control. If the <level> value is not specified, the thresholds are defined the same as the
ones for broadcast storm control in Global mode.
Default
Format
Mode
9.2.4.1 no storm-control broadcast
This command disables broadcast storm recovery mode.
Format
Mode

9.2.5 storm-control multicast

This command enables multicast packet storm recovery mode on the port level. If the
mode is enabled, multicast storm recovery with high and low thresholds is implemented.
The <level> value is in a range of 0 to 100 (in percentage). Value of 0 means no storm
control. If <level> value is not specified, the thresholds are defined same as the ones for
broadcast storm control in Global mode.
Default
Format
Mode
Port-Based Traffic Control Commands
no storm-control unicast all
Global Config
enable
storm-contol broadcast [<level>]
Interface Config
no storm-control broadcast [<level>]
Interface Config
enable
storm-control multicast [<level>]
Interface Config
v1.0, October 2008
9-7