Show Logging Traplogs; Cli Command Logging Command; Logging Cli-Command; Section 18.4 "Cli Command Logging Command - NETGEAR GSM7248R Command Line Interface Reference Manual

Command Line Interface Reference for the ProSafe 7200RS Series Layer-2 Stackable Switches

18.3.12 show logging traplogs

This command displays SNMP trap events and statistics.
Format
Mode
Number of Traps
Since Last Reset
Trap Log
Capacity
Number of Traps
Since Log Last
Viewed
Log
System Time Up
Trap

18.4 CLI Command Logging Command

This section describes the commands you use to configure CLI Command Logging.

18.4.1 logging cli-command

This command enables the CLI command logging feature, which enables the 7200RS
Series Stackable Switch software to log all CLI commands issued on the system.
Default
Format
Mode
18.4.1.1 no logging cli-command
This command disables the CLI command Logging feature.
Format
Mode
System Maintenance Commands
show logging traplogs
Privileged EXEC
Shows the number of traps since the last boot.
Shows the number of traps the system can retain.
Shows the number of new traps since the command was last
executed.
Shows the log number.
Shows how long the system had been running at the time the
trap was sent.
Shows the text of the trap message.
enabled
logging cli-command
Global Config
no logging cli-command
Global Config
v1.0, October 2008
18-27