Vlan Acceptframe; Vlan Ingressfilter - NETGEAR GSM7248R Command Line Interface Reference Manual

Command Line Interface Reference for the ProSafe 7200RS Series Layer-2 Stackable Switches
6.1.4.1 no vlan
This command deletes an existing VLAN. The ID is a valid VLAN identification number
(ID 1 is reserved for the default VLAN). The VLAN range is 1-4093.
Format
Mode

6.1.5 vlan acceptframe

This command sets the frame acceptance mode per interface. For VLAN Only mode,
untagged frames or priority frames received on this interface are discarded. For Admit All
mode, untagged frames or priority frames received on this interface are accepted and
assigned the value of the interface VLAN ID for this port. With either option, VLAN
tagged frames are forwarded in accordance with the IEEE 802.1Q VLAN Specification.
Default
Format
Mode
6.1.5.1 no vlan acceptframe
This command sets the frame acceptance mode per interface to Admit All. For Admit All
mode, untagged frames or priority frames received on this interface are accepted and
assigned the value of the interface VLAN ID for this port. With either option, VLAN
tagged frames are forwarded in accordance with the IEEE 802.1Q VLAN Specification.
Format
Mode

6.1.6 vlan ingressfilter

This command enables ingress filtering. If ingress filtering is disabled, frames received
with VLAN IDs that do not match the VLAN membership of the receiving interface are
admitted and forwarded to ports that are members of that VLAN.
Default
Format
Mode
VLAN Commands
no vlan <1-4093>
VLAN Config
all
vlan acceptframe {vlanonly | all}
Interface Config
no vlan acceptframe {vlanonly | all}
Interface Config
disabled
vlan ingressfilter
Interface Config
v1.0, October 2008
6-3