Show Arp Brief - NETGEAR GSM7248R Command Line Interface Reference Manual

Command Line Interface Reference for the ProSafe 7200RS Series Layer-2 Stackable Switches
IP Address
MAC Address
Interface
Type
Age

14.1.11 show arp brief

This command displays the brief Address Resolution Protocol (ARP) table information.
Format
Mode
Age Time
(seconds)
Response Time
(seconds)
Retries
Cache Size
Dynamic Renew
Mode
Total Entry Count
Current / Peak
Static Entry Count
Current / Max
14-6
Is the IP address of a device on a subnet attached to an exist-
ing routing interface.
Is the hardware MAC address of that device.
Is the routing unit/slot/port associated with the device ARP
entry.
Is the type that was configured into the unit. The possible val-
ues are Local, Gateway, Dynamic and Static.
This field displays the current age of the ARP entry since last
refresh (in hh:mm:ss format
show arp brief
Privileged EXEC
Is the time it takes for an ARP entry to age out. This value
was configured into the unit. Age time is measured in sec-
onds.
Is the time it takes for an ARP request timeout. This value
was configured into the unit. Response time is measured in
seconds.
Is the maximum number of times an ARP request is retried.
This value was configured into the unit.
Is the maximum number of entries in the ARP table. This
value was configured into the unit.
Displays whether the ARP component automatically attempts
to renew dynamic ARP entries when they age out.
Field listing the total entries in the ARP table and the peak
entry count in the ARP table.
Field listing the static entry count in the ARP table and maxi-
mum static entry count in the ARP table.
v1.0, October 2008
Routing Commands