Sntp Client Port; Sntp Unicast Client Poll-Interval; Sntp Unicast Client Poll-Timeout - NETGEAR GSM7248R Command Line Interface Reference Manual

Command Line Interface Reference for the ProSafe 7200RS Series Layer-2 Stackable Switches

4.3.3 sntp client port

This command sets the SNTP client port id to a value from 1-65535.
Default
Format
Mode
4.3.3.1 no sntp client port
This command resets the SNTP client port back to its default value.
Format
Mode

4.3.4 sntp unicast client poll-interval

This command sets the poll interval for SNTP unicast clients in seconds as a power of two
where
<poll-interval>
is from 17 to 16284, the value is interpreted to be in units of seconds.
Default
Format
Mode
4.3.4.1 no sntp unicast client poll-interval
This command resets the poll interval for SNTP unicast clients to its default value.
Format
Mode

4.3.5 sntp unicast client poll-timeout

This command sets the poll timeout for SNTP unicast clients in seconds to a value from 1-
30.
Default
Format
Mode
4-12
123
sntp client port <portid>
Global Config
no sntp client port
Global Config
can be a value from 6 to 16. When the value of the poll interval
6
sntp unicast client poll-interval <poll-interval>
Global Config
no sntp unicast client poll-interval
Global Config
5
sntp unicast client poll-timeout <poll-timeout>
Global Config
v1.0, October 2008
Port and System Setup Commands