Storm-Control Multicast All; Storm-Control Unicast All - NETGEAR GSM7248R Command Line Interface Reference Manual

Command Line Interface Reference for the ProSafe 7200RS Series Layer-2 Stackable Switches
9.2.1.1 no storm-control broadcast
This command disables broadcast storm recovery mode.
The threshold implementation follows a percentage pattern. If the broadcast traffic on any
Ethernet port exceeds the high threshold percentage (as represented in
link speed, the switch discards the broadcasts traffic until the broadcast traffic returns to
the low threshold percentage or less. The full implementation is depicted in the
Format
Mode

9.2.2 storm-control multicast all

This command enables multicast storm recovery mode. If the mode is enabled, multicast
storm recovery with hight and low thresholds is implemented. The thresholds are defined
in the same way as for broadcast.
Default
Format
Mode
9.2.2.1 no storm-control multicast all
This command disables multicast storm recovery mode.
Format
Mode

9.2.3 storm-control unicast all

This command enables unknown unicast packet storm recovery mode. If the mode is
enabled, the unknown storm recovery with high and low thresholds is implemented. The
thresholds are defined same as the one for broadcast.
Default
Format
Mode
9-6
no storm-control broadcast
Global Config
disable
storm-control multicast all
Config
no storm-control multicast all
Global Config
disable
storm-control unicast all
Config
v1.0, October 2008
Table
Port-Based Traffic Control Commands
9-1) of the
Table 9-1.