Storm-Control Unicast; Storm-Control Flowcontrol - NETGEAR GSM7248R Command Line Interface Reference Manual

Command Line Interface Reference for the ProSafe 7200RS Series Layer-2 Stackable Switches
9.2.5.1 no storm-control multicast
This command disables multicast storm recovery mode.
Format
Mode

9.2.6 storm-control unicast

This command enables unknown unicast packet storm recovery mode in per-port level. If
the mode is enabled, storm recovery with high and low thresholds is implemented. The
<level> value is in a range of 0 to 100 (in percentage). A value of 0 means no storm
control. If the <level> value is not specified, the thresholds are defined the same as the
ones for broadcast storm control in Global mode.
Default
Format
Mode
9.2.6.1 no storm-control unicast
This command disables unicast storm recovery mode.
Format
Mode

9.2.7 storm-control flowcontrol

This command enables 802.3x flow control for the switch and only applies to full-duplex
mode ports.
Note: 802.3x flow control works by pausing a port when the port becomes
Default
Format
Mode
9-8
no storm-control multicast [<level>]
Interface Config
enable
storm-control unicast [<level>]
Interface Config
no storm-control unicast [<level>]
Interface Config
oversubscribed and dropping all traffic for small bursts of time during the
congestion condition. This can lead to high-priority and/or network control
traffic loss.
disabled
storm-control flowcontrol
Global Config
v1.0, October 2008
Port-Based Traffic Control Commands