Class Of Service (Cos) Commands - NETGEAR GSM7248R Command Line Interface Reference Manual

This section describes the Quality of Service (QoS) commands available in the 7200RS
Series Stackable Switch CLI.
This section contains the following topics:
• Section 13.1 "Class of Service (CoS) Commands" on page 1
• Section 13.2 "Differentiated Services (DiffServ) Commands" on page 7
• Section 13.3 "DiffServ Class Commands" on page 9
• Section 13.4 "DiffServ Policy Commands" on page 16
• Section 13.5 "DiffServ Service Commands" on page 21
• Section 13.6 "DiffServ Show Commands" on page 22
• Section 13.7 "MAC Access Control List (ACL) Commands" on page 29
• Section 13.8 "IP Access Control List (ACL) Commands" on page 33
The commands in this section are in one of two functional groups:
• Configuration Commands are used to configure features and options of the switch. For
every configuration command there is a show command that will display the
configuration setting.
• Show commands are used to display device settings, statistics and other information.

13.1 Class of Service (CoS) Commands

This section describes the commands you use to configure and view Class of Service
(CoS) settings for the switch. The commands in this section allow you to control the
priority and transmission rate of traffic.
Note: Commands you issue in the Interface Config mode only affect a single
Quality of Service (QoS) Commands
Quality of Service (QoS) Commands
interface. Commands you issue in the Global Config mode apply to all
interfaces.
v1.0, October 2008
Chapter 13
13-1