Ip Dhcp Pool; Client-Identifier - NETGEAR GSM7248R Command Line Interface Reference Manual

Command Line Interface Reference for the ProSafe 7200RS Series Layer-2 Stackable Switches

7.1 ip dhcp pool

This command configures a DHCP address pool name on a DHCP server and enters
DHCP pool configuration mode.
Default
Format
Mode
Note: The CLI mode changes to DHCP Pool Config mode when you successfully
7.1.0.1 no ip dhcp pool
This command removes the DHCP address pool. The name should be previously
configured pool name.
Format
Mode

7.1.1 client-identifier

This command specifies the unique identifier for a DHCP client. Unique-identifier is a
valid notation in hexadecimal format. In some systems, such as Microsoft DHCP clients,
the client identifier is required instead of hardware addresses. The unique-identifier is a
concatenation of the media type and the MAC address. For example, the Microsoft client
identifier for Ethernet address c819.2488.f177 is 01c8.1924.88f1.77 where 01 represents
the Ethernet media type. For more information, refer to the "Address Resolution Protocol
Parameters" section of RFC 1700, Assigned Numbers for a list of media type codes.
Default
Format
Mode
7.1.1.1 no client-identifier
This command deletes the client identifier.
Format
Mode
7-2
none
ip dhcp pool <name>
Global Config
execute this command.
no ip dhcp pool <name>
Global Config
none
client-identifier <uniqueidentifier>
DHCP Pool Config
no client-identifier
DHCP Pool Config
v1.0, October 2008
DHCP Commands