Hardware-Address; Host - NETGEAR GSM7248R Command Line Interface Reference Manual

Command Line Interface Reference for the ProSafe 7200RS Series Layer-2 Stackable Switches
7.1.4.1 no dns-server
This command removes the DNS Server list.
Format
Mode

7.1.5 hardware-address

This command specifies the hardware address of a DHCP client. Hardware-address is the
MAC address of the hardware platform of the client consisting of 6 bytes in dotted
hexadecimal format. Type indicates the protocol of the hardware platform. It is 1 for 10
MB Ethernet and 6 for IEEE 802.
Default
Format
Mode
7.1.5.1 no hardware-address
This command removes the hardware address of the DHCP client.
Format
Mode

7.1.6 host

This command specifies the IP address and network mask for a manual binding to a DHCP
client. Address and Mask are valid IP addresses; each made up of four decimal bytes
ranging from 0 to 255. IP address 0.0.0.0 is invalid. The prefix-length is an integer from 0
to 32
Default
Format
Mode
7.1.6.1 no host
This command removes the IP address of the DHCP client.
Format
Mode
7-4
no dns-server
DHCP Pool Config
ethernet
hardware-address <hardwareaddress> [type]
DHCP Pool Config
no hardware-address
DHCP Pool Config
none
host <address> [mask | prefix-length]
DHCP Pool Config
no host
DHCP Pool Config
v1.0, October 2008
DHCP Commands