Mac Access-Group; Show Mac Access-Lists - NETGEAR GSM7248R Command Line Interface Reference Manual

Command Line Interface Reference for the ProSafe 7200RS Series Layer-2 Stackable Switches

13.7.4 mac access-group

This command attaches a specific MAC Access Control List (ACL) identified by
to an interface in a given direction. The
MAC ACL.
An optional sequence number may be specified to indicate the order of this mac access list
relative to other mac access lists already assigned to this interface and direction. A lower
number indicates higher precedence order. If a sequence number is already in use for this
interface and direction, the specified mac access list replaces the currently attached mac
access list using that sequence number. If the sequence number is not specified for this
command, a sequence number that is one greater than the highest sequence number
currently in use for this interface and direction is used.
This command specified in 'Interface Config' mode only affects a single interface, whereas
the 'Global Config' mode setting is applied to all interfaces. The 'Interface Config' mode
command is only available on platforms that support independent per-port class of service
queue configuration.
Format
Modes
13.7.4.1 no mac access-group
This command removes a MAC ACL identified by
direction.
Format
Modes

13.7.5 show mac access-lists

This command displays a MAC access list and all of the rules that are defined for the
MAC ACL. The [name] parameter is used to identify a specific MAC ACL to display.
Format
Mode
Rule Number
13-32
parameter must be the name of an existing
<name>
mac access-group <name> in [sequence <1-
4294967295>]
Global Config
Interface Config
no mac access-list <name> in
Global Config
Interface Config
show mac access-lists [name]
Privileged EXEC
The ordered rule number identifier defined within the MAC
ACL.
v1.0, October 2008
from the interface in a given
<name>
Quality of Service (QoS) Commands
<name>