Ip Igmpsnooping Interfacemode; Ip Igmpsnooping Groupmembership-Interval - NETGEAR GSM7248R Command Line Interface Reference Manual

Command Line Interface Reference for the ProSafe 7200RS Series Layer-2 Stackable Switches

15.1.2 ip igmpsnooping interfacemode

This command enables IGMP Snooping on all interfaces. If an interface has IGMP
Snooping enabled and you enable this interface for routing or enlist it as a member of a
port-channel (LAG), IGMP Snooping functionality is disabled on that interface. IGMP
Snooping functionality is re-enabled if you disable routing or remove port-channel (LAG)
membership from an interface that has IGMP Snooping enabled.
Default
Format
Mode
15.1.2.1 no ip igmpsnooping interfacemode
This command disables IGMP Snooping on all interfaces.
Format
Mode

15.1.3 ip igmpsnooping groupmembership-interval

This command sets the IGMP Group Membership Interval time on a VLAN, one interface
or all interfaces. The Group Membership Interval time is the amount of time in seconds
that a switch waits for a report from a particular group on a particular interface before
deleting the interface from the entry. This value must be greater than the IGMPv3
Maximum Response time value. The range is 2 to 3600 seconds.
Default
Format
Modes
15.1.3.1 no ip igmpsnooping groupmembership-interval
This command sets the IGMPv3 Group Membership Interval time to the default value.
Format
Modes
IGMP Snooping Commands
disabled
ip igmpsnooping interfacemode
Global Config
no ip igmpsnooping interfacemode
Global Config
260 seconds
ip igmpsnooping groupmembership-interval <vlanId>
<2-3600>
Interface Config
Global Config
VLAN Mode
no ip igmpsnooping groupmembership-interval
Interface Config
Global Config
VLAN Mode
v1.0, October 2008
15-3