Show Lldp Med Remote-Device; Show Lldp Med Remote-Device Detail - NETGEAR ProSafe GSM7224P User Manual

show lldp med remote-device

This command displays summary information about remote devices that transmit current
LLDP MED data to the system. You can show information about LLDP remote data received
on all ports or on a specific port.
Format
show lldp med remote-device {<unit/slot/port> | all}
Mode
Privileged EXEC
Term Definition
Interface
The interface in a unit/slot/port format.
Device Class
The Remote device's MED Classification. There are four different kinds of devices, three
of them represent the actual end points (classified as Class I Generic [IP Communication
Controller etc.], Class II Media [Conference Bridge etc.], Class III Communication [IP
Telephone etc]). The fourth device is Network Connectivity Device, which is typically a
LAN Switch/Router, IEEE 802.1 Bridge, IEEE 802.11 Wireless Access Point etc.
Example: The following shows example CLI display output for the command.
(Switch) #show lldp med remote-device all
LLDP MED Remote Device Summary
Local
Interface Remote ID
--------- ---------
1/0/8 1
1/0/9 2
1/0/10 3
1/0/11 4
1/0/12 5

show lldp med remote-device detail

Use this command to display detailed information about remote devices that transmit current
LLDP MED data to an interface on the system.
Format
show lldp med remote-device detail <unit/slot/port>
Mode
Privileged EXEC
Term Definition
Supported
Shows the supported capabilities that were received in MED TLV on this port.
Capabilities
Enabled
Shows the enabled capabilities that were enabled in MED TLV on this port.
capabilities
ProSafe Managed Switch
Device Class
------------
Class I
Not Defined
Class II
Class III
Network Con
Switching Commands
201