Show Ip Ospf Virtual-Link <Area_Id - NETGEAR GSM7248R Command Line Interface Reference Manual

Command Line Interface Reference for the ProSafe 7200RS Series Layer-2 Stackable Switches
14.5.51 show ip ospf virtual-link <area_id>
This command displays the OSPF Virtual Interface information for a specific area and
neighbor. The <
identifies the neighbor's Router ID.
Format
Modes
Area ID
Neighbor Router
ID
Hello Interval
Dead Interval
Iftransit Delay
Interval
Retransmit
Interval
Authentication
Type
State
Neighbor State
Routing Commands
> parameter identifies the area and the <
areaid
show ip ospf virtual-link <areaid> <neighbor>
Privileged EXEC
User EXEC
The area id of the requested OSPF area.
The input neighbor Router ID.
The configured hello interval for the OSPF virtual interface.
The configured dead interval for the OSPF virtual interface.
The configured transit delay for the OSPF virtual interface.
The configured retransmit interval for the OSPF virtual inter-
face.
The configured authentication type of the OSPF virtual inter-
face.
The OSPF Interface States are: down, loopback, waiting,
point-to-point, designated router, and backup designated
router. This is the state of the OSPF interface.
The neighbor state.
v1.0, October 2008
> parameter
neighbor
14-53