Match Source-Address Mac; Match Srcip; Match Srcl4Port - NETGEAR GSM7248R Command Line Interface Reference Manual

Command Line Interface Reference for the ProSafe 7200RS Series Layer-2 Stackable Switches
To specify the match condition using a numeric value notation, the protocol number is a
standard value assigned by IANA and is interpreted as an integer from 0 to 255.
Note: This command does not validate the protocol number value against the
Format
Mode

13.3.14 match source-address mac

This command adds to the specified class definition a match condition based on the source
MAC address of a packet. The <address
as six, two-digit hexadecimal numbers separated by colons (e.g., 00:11:22:dd:ee:ff). The
<macmask parameter is a layer 2 MAC address bit mask, which may not be contiguous,
>
and is formatted as six, two-digit hexadecimal numbers separated by colons (e.g.,
ff:07:23:ff:fe:dc).
Default
Format
Mode

13.3.15 match srcip

This command adds to the specified class definition a match condition based on the source
IP address of a packet. The
parameter specifies an IP address bit mask and must consist of a contiguous set of leading
1 bits.
Format
Mode

13.3.16 match srcl4port

This command adds to the specified class definition a match condition based on the source
layer 4 port of a packet using a single keyword or numeric notation.
To specify the match condition as a single keyword notation, the value for
one of the supported port name keywords (listed below).
Quality of Service (QoS) Commands
current list defined by IANA.
match protocol {protocol-name | <0-255>}
Class-Map Config
none
match source-address mac
Class-Map Config
<ipaddr>
match srcip <ipaddr> <ipmask>
Class-Map Config
v1.0, October 2008
parameter is any layer 2 MAC address formatted
>
<address> <macmask>
parameter specifies an IP address. The
<ipmask>
is
<portkey>
13-15