Show Ip Route Preferences - NETGEAR GSM7248R Command Line Interface Reference Manual

Command Line Interface Reference for the ProSafe 7200RS Series Layer-2 Stackable Switches
Network Address
Subnet Mask
Protocol
The following information displays for each Next Hop.
Next Hop
Interface
Next Hop IP
Address
Metric
Preference

14.2.17 show ip route preferences

This command displays detailed information about the route preferences. Route
preferences are used in determining the best route. Lower router preference values are
preferred over higher router preference values.
Format
Modes
Local
Static
OSPF Intra
OSPF Inter
OSPF Type-1
OSPF Type-2
RIP
14-16
Is a valid network address identifying the network on the
specified interface.
Is a mask of the network and host portion of the IP address
for the attached network.
Tells which protocol added the specified route. The possibili-
ties are: local, static, OSPF or RIP.
The outgoing router interface to use when forwarding traffic
to the next destination.
The outgoing router IP address to use when forwarding traffic
to the next router (if any) in the path toward the destination.
The cost associated with this route.
The administrative distance associated with this route.
show ip route preferences
Privileged EXEC
User EXEC
This field displays the local route preference value.
This field displays the static route preference value.
This field displays the OSPF Intra route preference value.
This field displays the OSPF Inter route preference value.
This field displays the OSPF Type-1 route preference value.
This field displays the OSPF Type-2 route preference value.
This field displays the RIP route preference value.
v1.0, October 2008
Routing Commands