Ip Ospf Hello-Interval; Ip Ospf Priority - NETGEAR GSM7248R Command Line Interface Reference Manual

Command Line Interface Reference for the ProSafe 7200RS Series Layer-2 Stackable Switches
14.5.30.1 no ip ospf dead-interval
This command sets the default OSPF dead interval for the specified interface.
Format
Mode

14.5.31 ip ospf hello-interval

This command sets the OSPF hello interval for the specified interface. The interval is the
length of time in seconds. The value for the length of time must be the same for all routers
attached to a network. Valid values range from 1 to 65535.
Default
Format
Mode
14.5.31.1 no ip ospf hello-interval
This command sets the default OSPF hello interval for the specified interface.
Format
Mode

14.5.32 ip ospf priority

This command sets the OSPF priority for the specified router interface. The priority of the
interface is a priority integer from 0 to 255. A value of 0 indicates that the router is not
eligible to become the designated router on this network.
Default
Format
Mode
14.5.32.1 no ip ospf priority
This command sets the default OSPF priority for the specified router interface.
Format
Mode
14-38
no ip ospf dead-interval
Interface Config
10
ip ospf hello-interval <1-65535>
Interface Config
no ip ospf hello-interval
Interface Config
1, which is the highest router priority.
ip ospf priority <0-255>
Interface Config
no ip ospf priority
Interface Config
v1.0, October 2008
Routing Commands