Front Panel Stacking Commands; Stack-Port - NETGEAR GSM7248R Command Line Interface Reference Manual

Command Line Interface Reference for the ProSafe 7200RS Series Layer-2 Stackable Switches
If you do not supply a value for
Switch Index
(SID)
Model Identifier
Management
Preference
Code Version
If you supply a value for
Switch Type
Model Identifier
Switch
Description

16.2 Front Panel Stacking Commands

This section describes the commands you use to view and configure front panel stacking
information.

16.2.1 stack-port

Note: This command does not apply to these models: GSM7352S, GSM7352S,
This command sets front panel stacking per port to either stack or ethernet mode.
Default
Format
Mode
16-10
[switchindex]
This field displays the index into the database of supported
switch types. This index is used when preconfiguring a mem-
ber to be added to the stack.
This field displays the model identifier for the supported
switch type.
This field indicates the management preference value of the
switch type.
This field displays the code load target identifier of the switch
type.
[switchindex]
This field displays the 32-bit numeric switch type for the sup-
ported switch.
This field displays the model identifier for the supported
switch type.
This field displays the description for the supported switch
type.
and GSM7328FS>
stack
stack-port <unit/slot/port> [ethernet | stack]
Stack Global Config
v1.0, October 2008
, the following output appears:
, the following output appears:
Stacking Commands