Configuring Snmp - ZyXEL Communications NXC5200 User Manual

Hide thumbs Also See for NXC5200:

Table of Contents

Chapter 33 System

33.10.3 Configuring SNMP

To change your NXC's SNMP settings, click Configuration > System > SNMP

tab. The screen appears as shown. Use this screen to configure your SNMP

settings, including from which zones SNMP can be used to access the NXC. You

can also specify from which IP addresses the access can come.

Figure 235 Configuration > System > SNMP

The following table describes the labels in this screen.

Table 190 Configuration > System > SNMP

Select the check box to allow or disallow the computer with the IP

address that matches the IP address(es) in the Service Control table to

access the NXC using this service.

You may change the server port number for a service if needed, however

you must use the same port number in order to use that service for

remote management.

Enter the Get Community, which is the password for the incoming Get

and GetNext requests from the management station. The default is

public and allows all requests.

Enter the Set community, which is the password for incoming Set

requests from the management station. The default is private and allows

all requests.

Type the trap community, which is the password sent with each trap to

the SNMP manager. The default is public and allows all requests.

NXC5200 User's Guide

Nxc5200 - v2.20