ZyXEL Communications NXC5200 User Manual page 122

Hide thumbs Also See for NXC5200:

Table of Contents

Chapter 7 Monitor

You use the Traffic Statistics screen to tell the NXC when to start and when to

stop collecting information for these reports. You cannot schedule data collection;

you have to start and stop it manually in the Traffic Statistics screen.

Figure 34 Monitor > System Status > Traffic Statistics

There is a limit on the number of records shown in the report. See

Table 31 Monitor > System Status > Traffic Statistics

Data Collection

for more information. The following table describes the labels in this

Select this to have the NXC collect data for the report. If the NXC has

already been collecting data, the collection period displays to the right.

The progress is not tracked here real-time, but you can click the

Refresh button to update it.

Click Apply to save your changes back to the NXC.

Click Reset to return the screen to its last-saved settings.

Select the interface from which to collect information. You can collect

information from Ethernet or VLAN interfaces.

Select the type of report to display. Choices are:

Host IP Address/User - displays the IP addresses or users with the

most traffic and how much traffic has been sent to and from each one.

Service/Port - displays the most-used protocols or service ports and

the amount of traffic for each one.

Web Site Hits - displays the most-visited Web sites and how many

times each one has been visited.

Each type of report has different information in the report (below).

Click this button to update the report display.

NXC5200 User's Guide

Troubleshooting

Nxc5200 - v2.20