Configuring Ssh - ZyXEL Communications NXC5200 User Manual

Hide thumbs Also See for NXC5200:

Table of Contents

33.7.4 Configuring SSH

Click Configuration > System > SSH to change your NXC's Secure Shell

settings. Use this screen to specify from which zones SSH can be used to manage

the NXC. You can also specify from which IP addresses the access can come.

Note: It is recommended that you disable Telnet and FTP when you configure SSH for

secure connections.

Figure 228 Configuration > System > SSH

The following table describes the labels in this screen.

Table 186 Configuration > System > SSH

Service Control This specifies from which computers you can access which NXC zones.

NXC5200 User's Guide

Select the check box to allow or disallow the computer with the IP

address that matches the IP address(es) in the Service Control table to

access the NXC CLI using this service.

Select the check box to have the NXC use both SSH version 1 and

version 2 protocols. If you clear the check box, the NXC uses only SSH

version 2 protocol.

You may change the server port number for a service if needed, however

you must use the same port number in order to use that service for

remote management.

Select the certificate whose corresponding private key is to be used to

identify the NXC for SSH connections. You must have certificates already

configured in the My Certificates screen.

Click this to create a new entry. Select an entry and click Add to create a

new entry after the selected entry.

Double-click an entry or select it and click Edit to be able to modify the

entry's settings.

Chapter 33 System

Nxc5200 - v2.20