Configuring Snmp - ZyXEL Communications NXC2500 User Manual

28.11.3 Configuring SNMP

Your NXC can act as an SNMP agent, which allows a manager station to manage and monitor the
NXC through the network.
To change your NXC's SNMP settings, click Configuration > System > SNMP tab. The screen
appears as shown. Use this screen to configure your SNMP settings, including from which zones
SNMP can be used to access the NXC. You can also specify from which IP addresses the access can
come and configure user profiles that define allowed SNMPv3 access.
Figure 191 Configuration > System > SNMP
The following table describes the labels in this screen.
Table 166 Configuration > System > SNMP
LABEL
Enable
Server Port
Trap
Chapter 28 System
DESCRIPTION
Select the check box to allow or disallow the computer with the IP address that matches the
IP address(es) in the Service Control table to access the NXC using this service.
You may change the server port number for a service if needed, however you must use the
same port number in order to use that service for remote management.
NXC Series User's Guide
322