Resetting The Nxc; Getting More Troubleshooting Help - ZyXEL Communications NXC5200 User Manual

Hide thumbs Also See for NXC5200:

Table of Contents

In the Monitor > Wireless > AP Info > AP List page, there is no load balancing

indicator associated with any APs assigned to the load balancing task.

• Check to be sure that the AP profile which contains the load balancing settings is

correctly assigned to the APs in question.

• The load balancing task may have been terminated because further load

balancing on the APs in question is no longer required.

39.2 Resetting the NXC

If you cannot access the NXC by any method, try restarting it by turning the

power off and then on again. If you still cannot access the NXC by any method or

you forget the administrator password(s), you can reset the NXC to its factory-

default settings. Any configuration files or shell scripts that you saved on the NXC

should still be available afterwards.

Use the following procedure to reset the NXC to its factory-default settings. This

overwrites the settings in the startup-config.conf file with the settings in the

system-default.conf file.

Note: This procedure removes the current configuration.

Make sure the SYS LED is on and not blinking.

Press the RESET button and hold it until the SYS LED begins to blink. (This

usually takes about five seconds.)

Release the RESET button, and wait for the NXC to restart.

You should be able to access the NXC using the default settings.

Search for support information for your model at www.zyxel.com for more

troubleshooting suggestions.

NXC5200 User's Guide

Chapter 39 Troubleshooting

Nxc5200 - v2.20