Configuration Menu - ZyXEL Communications NXC5200 User Manual

Chapter 3 The Web Configurator

3.3.2.3 Configuration Menu

Use the configuration menu screens to configure the NXC's features.
Table 6 Configuration Menu Screens Summary
FOLDER OR
LINK
Licensing
Registration
Signature
Update
Wireless
Controller
AP
Management
MON Mode
Load
Balancing
DCS
Network
Interface
Routing
Zone
NAT
ALG
IP/MAC
Binding
Captive Portal
46
TAB FUNCTION
Registration Register the device and activate trial services.
Service View the licensed service status and upgrade
licensed services.
Anti-Virus Update anti-virus signatures immediately or by a
schedule.
IDP/AppPatrol Update IDP signatures immediately or by a
schedule.
System Protect Update system-protect signatures immediately or
by a schedule.
Configure how the NXC handles APs that newly
connect to the network.
Edit wireless AP information, remove APs, and
reboot them.
Configure how the NXC monitors for rogue APs.
Configure load balancing for traffic moving to and
from wireless clients.
Configure dynamic wireless channel selection.
Ethernet Manage Ethernet interfaces and virtual Ethernet
interfaces.
VLAN Create and manage VLAN interfaces and virtual
VLAN interfaces.
Policy Route Create and manage routing policies.
Static Route Create and manage IP static routing information.
Configure zones used to define various policies.
Set up and manage port forwarding rules.
Configure SIP, H.323, and FTP pass-through
settings.
Summary Configure IP to MAC address bindings for devices
connected to each supported interface.
Exempt List Configure ranges of IP addresses to which the NXC
does not apply IP/MAC binding.
Captive Portal Assign the captive portal web page to various
network services.
Login Page Assign and customize the login page user's see
when they hit the captive portal.
NXC5200 User's Guide