ZyXEL Communications NXC5200 User Manual page 365

The following table describes the labels in this screen.
Table 131 Device HA > Active-Passive Mode > Edit Monitored Interface
LABEL
Enable
Monitored
Interface
Interface
Name
Virtual Router
IP (VRIP) /
Subnet Mask
Management
IP
Manage IP
Subnet Mask
OK
Cancel
NXC5200 User's Guide
DESCRIPTION
Select this to have device HA monitor the status of this interface's
connection.
This identifies the interface.
Note: Do not connect the bridge interfaces on two NXCs without
device HA activated on both. Doing so could cause a
broadcast storm.
Either activate device HA before connecting the bridge interfaces or
disable the bridge interfaces, connect the bridge interfaces, activate
device HA, and finally reactivate the bridge interfaces.
This is the interface's (static) IP address and subnet mask in the virtual
router. Whichever NXC is currently serving as the master uses this
virtual router IP address and subnet mask. These fields are blank if the
interface is a DHCP client or has no IP settings.
Enter the interface's IP address for management access. You can use
this IP address to access the NXC whether it is the master or a backup.
This management IP address should be in the same subnet as the
interface IP address.
Enter the subnet mask of the interface's management IP address.
Click OK to save your changes back to the NXC.
Click Cancel to exit this screen without saving your changes.
Chapter 23 Device HA
365