Telnet - ZyXEL Communications NXC5200 User Manual

Chapter 33 System
Enter "ssh –1 192.168.1.1". This command forces your computer to connect to
2
the NXC using SSH version 1. If this is the first time you are connecting to the NXC
using SSH, a message displays prompting you to save the host information of the
NXC. Type "yes" and press [ENTER].
Then enter the password to log in to the NXC.
Figure 231 SSH Example 2: Log in
$ ssh –1 192.168.1.1
The authenticity of host '192.168.1.1 (192.168.1.1)' can't be established.
RSA1 key fingerprint is 21:6c:07:25:7e:f4:75:80:ec:af:bd:d4:3d:80:53:d1.
Are you sure you want to continue connecting (yes/no)? yes
Warning: Permanently added '192.168.1.1' (RSA1) to the list of known hosts.
Administrator@192.168.1.1's password:
The CLI screen displays next.
3

33.8 Telnet

You can use Telnet to access the NXC's command line interface. Specify which
zones allow Telnet access and from which IP address the access can come. Click
Configuration > System > TELNET to configure your NXC for remote Telnet
access. Use this screen to specify from which zones Telnet can be used to manage
the NXC. You can also specify from which IP addresses the access can come.
Figure 232 Configuration > System > TELNET
496
NXC5200 User's Guide