Add/Edit Service Rule - ZyXEL Communications NXC5200 User Manual

Chapter 28 Services
Table 154 Configuration > Object > Service > Service (continued)
LABEL
Name
Content

28.2.1 Add/Edit Service Rule

The Add/Edit Service Rule screen allows you to create a new service or edit an
existing one. To access this screen, go to the Service screen and click either the
Add icon or an Edit icon.
Figure 188 Configuration > Object > Service > Service > Add/Edit
The following table describes the labels in this screen.
Table 155 Configuration > Object > Service > Service > Add/Edit
LABEL
Name
IP Protocol
Starting Port
Ending Port
ICMP Type
IP Protocol
Number
OK
Cancel
416
DESCRIPTION
This field displays the name of each service.
This field displays a description of each service.
DESCRIPTION
Type the name used to refer to the service. You may use 1-31
alphanumeric characters, underscores(
character cannot be a number. This value is case-sensitive.
Select the protocol the service uses. Choices are: TCP, UDP, ICMP, and
User Defined.
This field appears if the IP Protocol is TCP or UDP. Specify the port
number(s) used by this service. If you fill in one of these fields, the
service uses that port. If you fill in both fields, the service uses the range
of ports.
This field appears if the IP Protocol is ICMP Type.
Select the ICMP message used by this service. This field displays the
message text, not the message number.
This field appears if the IP Protocol is User Defined.
Enter the number of the next-level protocol (IP protocol). Allowed values
are 0 - 255.
Click OK to save your changes back to the NXC.
Click Cancel to exit this screen without saving your changes.
), or dashes (-), but the first
_
NXC5200 User's Guide