Starting And Stopping The Nxc - ZyXEL Communications NXC5200 User Manual

Chapter 1 Introduction
Command-Line Interface (CLI)
The CLI allows you to use text-based commands to configure the NXC. You can
access it using remote management (for example, SSH or Telnet) or via the
console port. See the Command Reference Guide for more information.
Console Port
You can use the console port to manage the NXC using CLI commands. See the
Command Reference Guide for more information about the CLI.
The default settings for the console port are as follows.
Table 2 Console Port Default Settings
SETTING
Speed
Data Bits
Parity
Stop Bit
Flow Control

1.5 Starting and Stopping the NXC

Here are some of the ways to start and stop the NXC.
Always use Maintenance > Shutdown or the shutdown command
before you turn off the NXC or remove the power. Not doing so can
cause the firmware to become corrupt.
Table 3 Starting and Stopping the NXC
METHOD
Turning on the
power
Rebooting the NXC
Using the RESET
button
32
VALUE
115200 bps
8
None
1
Off
DESCRIPTION
A cold start occurs when you turn on the power to the NXC. The NXC
powers up, checks the hardware, and starts the system processes.
A warm start (without powering down and powering up again)
occurs when you use the Reboot button in the Reboot screen or
when you use the reboot command. The NXC writes all cached data
to the local storage, stops the system processes, and then does a
warm start.
If you press the RESET button, the NXC sets the configuration to its
default values and then reboots.
NXC5200 User's Guide