Chapter 23 Device HA
Table 130 Configuration > Device HA > Active-Passive Mode (continued)
LABEL
Apply
Reset
23.3.1 Edit Monitored Interface
This screen lets you enable or disable monitoring of an interface and set the
interface's management IP address and subnet mask. To access this screen, click
Configuration > Device HA > Active-Passive Mode > Edit.
If you configure device HA settings for an Ethernet interface and later add the
Ethernet interface to a bridge, the NXC retains the interface's device HA settings
and uses them again if you later remove the interface from the bridge. If the
bridge is later deleted or the interface is removed from it, Device HA will recover
the interface's setting.
A bridge interface's device HA settings are not retained if you delete the bridge
interface.
Figure 161 Device HA > Active-Passive Mode > Edit Monitored Interface
364
DESCRIPTION
This appears when the NXC is currently using active-passive mode
device HA. Click Apply to save your changes back to the NXC.
Click Reset to return the screen to its last-saved settings.
NXC5200 User's Guide