Example Interface And Zone Configuration - ZyXEL Communications NXC5200 User Manual

4.3.2 Example Interface and Zone Configuration

This section introduces the NXC's default zone member physical interfaces and the
default configuration of those interfaces. The following figure uses letters to
denote public IP addresses or part of a private IP address.
Figure 18 Default Network Topology
Table 13 NXC Sample Topology
PORT
P1~P8
CONSOLE N/A
• The LAN zone contains the ge1~ ge8 interfaces (physical ports P1~P8). By
default, all LAN interfaces are put in vlan0.
• The WLAN zone contains Access Points (APs) that are available to the public.
These APs uses private IP addresses that can be assigned by an upstream DHCP
server (default) or the NXC itself in some configurations.
• The console port is not in a zone and can be directly accessed by a computer
attached to it using a special console-to-Ethernet adapter.
NXC5200 User's Guide
INTERFACE ZONE
ge1~ge8 LAN
(vlan0)
WLAN
None
Chapter 4 Configuration Basics
IP ADDRESS AND DHCP
SETTINGS
192.168.1.1, DHCP server
enabled
DHCP clients
None
SUGGESTED USE WITH
DEFAULT SETTINGS
Dedicated LAN
connections
Managed Wireless APs
Local management
61