Trunk And Station Modules; Global Analog Trunk Cartridge/Cli Cartridge - Nortel ICS Install Manual

218 / Planning the installation

Trunk and Station Modules

If you are not adding digital T1 trunks to your system, or
expanding to a mega configuration, you may reuse your
existing copper Trunk and/or Station Modules with the
Modular 0X32 ICS in MICS 7.1/XC 7.1. One 6-port copper
expansion cartridge can be supported on the maxi
configuration.
If you are adding digital T1 trunks to your system or
expanding to a mega configuration, you must replace any
copper Trunk and/or Station Modules with the new modules
that have fiber connectors, and use a new fiber Expansion
Cartridge in the ICS. You can reuse your old Trunk Cartridges
in the new Trunk Module with fiber connectors.
Trunk modules cannot be installed on the second expansion
(6-port) cartridge. You must relocate station modules to the
second expansion cartridge to free up ports on the first 6-port
expansion cartridge.

Global Analog Trunk Cartridge/CLI Cartridge

These cartridges have dip switches that may need to be set if
your system is not running with the North American profile
(Profile 1). Set the dip switches before you install the
cartridge.
GATC dip switch settings (default is North America)(
Modular ICS 7.1 Installer Guide N0130943 02