Call Log Set; Extl Vmsg Set - Nortel ICS Install Manual

358 / Terminals&Sets
Tip -
information for calls on an external line, it must also be
programmed to appear and ring or ring for that line.
For systems that subscribe to Call Display services, Caller ID
can be viewed on any telephone by entering the Call
Information feature code ≤°⁄⁄. See the Telephone
Feature Card or Modular ICS 7.1 System Coordinator Guide
for more information.
Call information does not automatically appear when the
telephone has an Answer DN, or belongs to a Ring group
activated by Ringing Service. Call information is still available
for these calls by pressing ≤°⁄⁄.

Call log set

When you choose the Line variable for Call log under Featr
settings (Call log on page 437), you can use this heading to
determine which lines will log calls. The assigned lines do not
have to be ringing lines, but they must have an appearance on
the telephone.
For each assigned line, press CHANGE to select the setting: N
(No) or Y (Yes).

Extl VMsg set

If you subscribe to an external voice message service or central
voice mail system that is not directly connected to your ICS,
you can access that service through your Norstar system. The
external voice message setting controls where the indicator
shows up when there is a voice message waiting on a particular
line. The line must be assigned to appear on that telephone.
Press CHANGE to select the setting: N (No) or Y (Yes).
Modular ICS 7.1 Installer Guide
In order for a telephone to display the Call Display
N0130943 02