Line Pool Access - Nortel ICS Install Manual

TIPs -
position (CAP) with eKIMs, can provide extra line buttons if
more than 10 (7316E digital phone) lines are assigned to the
telephone attached to the modules. The extra lines
automatically overflow onto the buttons on the module, as they
are programmed. Note that new line assignments may
overwrite existing programming on the eKIM.
Note: The eKIM must be set up under System prgrmng, CAP/
KIM assgn to accommodate line buttons. If the modules are
not set up in system programming to be CAPs, the lines will
remain assigned to the 7316E, but will not show up on a button
on that telephone.

Line pool access

This setting allows a telephone to access one or more of the 15
line pools available (A to O). When you assign a given line
pool, the telephone being programmed can access any lines in
that line pool.
Press ≠, then press ' to scroll through the
settings and display the line pool you want to program access
to. Press CHANGE to select the setting: N (No) and Y (Yes).
There can be a maximum of two on-core DTI cards (PRI) on a
Norstar system, regardless of profile.
Four line pools are available for PRI lines for profiles 1 and 4,
which support two on-core DTI cards and one off-core DTI
card (Off-core DTI card on page 219). The four possible line
pools are PRI-A, PRI-B, PRI-C, or PRI-D.
• Only PRI lines can belong to a PRI pool. PRI lines cannot
belong to Line Pools A through O.
• All lines on a single DTI card (PRI) belong to the same
pool.
N0130943 02
CAP line programming: A central answering
Terminals&Sets / 339
Modular ICS 7.1 Installer Guide