Trunk Module Line Numbering - Nortel ICS Install Manual

224 / Planning the installation

Trunk module line numbering

In MICS 6.0/MICS-XC 6.0 software, the line numbering for
all profiles was adjusted to accommodate the Profile 2 ETSI
requirement of 30 lines. The chart below shows the line
numbering transitions between the various versions of
software. Note also that target lines have been renumbered.
If you are upgrading to version 7.1 from a 6.0 system, no line
programming changes are required, however, note that an
additional 32 target lines have been added for Mega systems.
However, if you are upgrading from a system version previous
to 6.0, you will need to note the line changes and make the
programming adjustments.
Note: Line numbering varies, depending on the profile you
choose for your system, which type of trunk module
you are using, or what protocol you choose for the
module (DTI). Refer to TrunkMod on page 508.
Line numbering for upgrades
Module Cartridge
Cd1-Mod8
Mod 08 Cd2-Mod8
Cd3-Mod8
Cd1-Mod7
Mod 07 Cd2-Mod7
Cd3-Mod7
Cd1-Mod6
Mod 06 Cd2-Mod6
Cd3-Mod6
Cd1-Mod5
Mod 05 Cd2-Mod5
Cd3-Mod5
Modular ICS 7.1 Installer Guide
MICS 1.0 MICS 2.0,
and 3.0, 4.0, and
1.1 lines 5.0 lines
49-52 49-56
53-56 57-64
57-60 65-72
61-64 73-80
65-68 81-88
69-72 89-96
73-76 97-100
77-80 101-104
81-84 105-108
85-88 109-112
89-92 113-116
93-96 117-120
MICS 6.0, MICS 7.0
6.1 and and newer
6.1MR lines lines
61-68
69-76
77-84
85-92
93-100
101-108
109-112
113-116
117-120
121-124
125-128
129-132
N0130943 02