Nortel ICS Install Manual page 317

7. Press ' and enter the internal number of the
telephone that will be programmed or the internal numbers
of the first and last telephone in a range.
8. Press OK to proceed with the copy.
This step is not necessary when you are copying to a single
telephone.
You can also use COPY to duplicate the settings found in the
individual subheadings. The button is available in Line
access, Capabilities, User prefernces, Restrictions
and Telco features and will copy only the settings included
in the subheading.
If you press COPY in one of these subheadings, you will not be
asked to decide if user data will be copied. Otherwise, the
procedure is the same.
Tips -
of a range, follow the steps for making a single copy and keep
entering new numbers at the Copy to: display.
Depending on the activities going on in the system, a copy may
not take effect immediately. The brief display you see once you
have finished a copying session does not indicate the process
is complete.
You can leave the programming session even if the copy has
not been completed. If you exit programming, the system
continues copying, uninterrupted, until it is complete.
Event messages capture both the start and completion of the
copying process. For more information, see Event messages
on page 555.
Tips -
delay according to the number of rings. The ring counts used
are based on a North American standard of six seconds per
ring cycle. The actual delay time may be different for a device
other than a Norstar telephone.
N0130943 02
Copying telephone programming / 317
To copy to a group of telephones which are not part
Some programming settings allow you to choose a
Modular ICS 7.1 Installer Guide