Nortel ICS Install Manual page 346

346 / Terminals&Sets
Setting
Priority call
Hotline
Intrnl #
Extrnl #
<Extrnl>
facility
choice
Aux. ringer
Allow redirect
Redirect ring
ATA settings
ATA ans timer
Modular ICS 7.1 Installer Guide
Description
Select whether to allow this telephone to
interrupt calls or to override Do Not
Disturb at another telephone.
Select whether a telephone number will
be dialed automatically when a user lifts
the receiver or presses the handsfree
button.
Appears if Hotline is Intrnl
Appears if Hotline is Extrnl
Appears if Hotline is Extrnl and number is
specified.
Use routing tabl option routes numbers
through the Routing Table.
Target lines cannot be used as the
facility.
Select whether an auxiliary ringer (if
installed) will ring for incoming calls at
this telephone.
Select whether to allow this telephone to
redirect its lines.
Select whether a telephone rings briefly
when a call on one of its lines is
redirected by the Line Redirection feature
(≤°›).
Select the length of delay between the
last digit you dial and when the ATA
device is ready to receive DTMF tone.
To accommodate the device attached to
the ATA, you may need to change the
delay. If a modem or fax machine is
attached to the ATA, you will want to
keep the delay short. If a call to a fax
machine or modem cannot be
connected, try shortening the delay. If an
individual is dialing the number for a fax
machine or modem, you may want to
make the delay a little longer.
Options
Y, N
Intrnl, Extrnl,
None
Enter DN, None
None,
<up to 24 digits>
Use Prime line
Use line:
Pool code:
Use Routing tabl
Y, N
Y, N
Y, N
3, 5, 7, 10
N0130943 02