Enabling The Device; Returning To The Beginning - Nortel ICS Install Manual
Nortel norstar ics software: install guide
Hide thumbs
Also See for ICS:
- Quick start manual (36 pages) ,
- Supplementary manual (6 pages) ,
- User manual (138 pages)
Table of Contents
Advertisement
536 / Port/DN status
Enabling the device
When the display shows you that the device is disabled:
Press ENABLE. Enabling... briefly displays.
The device is immediately enabled and the display shows
Idle.
Tips -
either Disabled by sys. or Disabled by user. In this case,
the system is waiting to enable the module. This may occur after
someone has run a Maintenance session and used Module
status. You cannot enable the device until its module has been
enabled.
Individual lines cannot be disabled in Port/DN status. To
disable a Trunk Cartridge, see Module status on page 537.
Returning to the beginning
From the display showing the state of the device:
1. Press OK.
2. Press – until the you reach Port/DN status.
Modular ICS 7.1 Installer Guide
The display may briefly show Enabling..., then
Installer password required
Installer password required
N0130943 02
Advertisement
Table of Contents
Troubleshooting
