Line Coding - Nortel ICS Install Manual

Tips -
internal CSU turned on.

Line coding

Select the standard used by your T1 service provider for
encoding signals on the T1 lines.
Press CHANGE to select the setting: B8ZS or AMI.
Tips -
Consult your T1 service provider for the proper setting.
N0130943 02
This setting only appears for DTIs that have the
You must disable the Trunk Cartridge using
Module status in Maintenance before you can
change this setting. See Module status on page
537 for details.
This setting only appears for DTIs.
Enable Trunk Cartridges
If you disable any Trunk Cartridges to perform
programming, enable them now using Module
status in Maintenance or your system will not
function properly. See Module status on page
537 for information about enabling Trunk
Cartridges in Module status.
Hardware / 505
Modular ICS 7.1 Installer Guide