Direct-Dial; D-Dial1 - Nortel ICS Install Manual

448 / System prgrming
You have the choice of silently monitoring the conversation,
or providing a tone to the other two parties to indicate that the
line is being monitored. This setting is the same for all
supervisor telephones. Refer to the process below to determine
the setting.
1. Under Featr settings, press ≠. The display
shows Backgrnd music: N.
2. Press ' until the display shows Silent
Monitor: Y.
3. Press CHANGE to select Y or N.
4. Press ® to exit or ' to continue programming.
Refer to the MICS ICS 7.1 System Coordinator Guide for
information about using the Silent Monitoring feature.
Note: Some market profiles do not allow silent break-ins. In
those markets Silent Monitor can be disabled (set to N)
or a monitoring tone can be configured.

Direct-dial

Direct-dial allows you to dial a single system-wide digit that
can be used to call a specific telephone, called a Direct-dial
telephone. The most common example of a Direct-dial
telephone would be telephone for an operator, a receptionist,
or an attendant.

D-Dial1

For the direct-dial telephone, indicate whether it is an internal
or external number. A total of five Direct-dial telephones can
be programmed on the system.
Modular ICS 7.1 Installer Guide N0130943 02