Entering Programming For System Coordinators - Nortel ICS Install Manual

Entering programming for system coordinators

The person on staff who is in charge of making changes on the
Norstar system is called the system coordinator. The everyday
programming done by system coordinators is described in the
Modular ICS 7.1 System Coordinator Guide.
Some system coordinators need to be able to program more
advanced settings and functions in order to carry out the day-
to-day requests and upkeep of the Norstar. These coordinators
are usually dedicated communications specialists who work
with large Norstar systems or other telephone systems like
PBX or Centrex.
By using a special password, a system coordinator can see and
change many, but not all, of the programming settings used by
an installer. In this guide, programming that can only be
changed by an installer is marked in the heading. If you are
programming using the System Coordinator plus password,
you will not see these items when you move through the
menus. This level of access is documented in the Modular ICS
7.1 System Coordinator Guide.
1. Enter the System Coordinator plus codes on a
programming set by pressing
≤••Ç؈ÏÈÌ, which is the same as
≤••¤flfl‹››.
The display shows Password:.
2. Enter the System Coordinator plus password.
The default password is SCPLUS (727587).
The display shows Terminals&Sets ˆ. Three triangular
indicators º appear on the vertical display between the
rows of buttons.
3. Place the programming overlay over the buttons pointed to
by the indicators º.
N0130943 02
Programming / 333
Modular ICS 7.1 Installer Guide