Pri Dialing Plan Example For Two-Way Did - Nortel ICS Install Manual

To Public Network:
Routing Service

PRI dialing plan example for two-way DID

The following list shows the steps involved in configuring a
dialing plan for two-way DID which uses a Public service. In
this example the user dials the prefix 8 to place a call over a
PRI line.
Note: Call-by-call is not needed to have two-way DID.
in Hardware programming, configure the DTI card (PRI)
•
to use a Public protocol
• for incoming calls you need to program target lines to
match the DID digit that is being received on the PRI
interface
set Dial Out to None
•
select PRI-A as the line pool
•
set SrvcType to Public
•
in Services programming access Routing Service to
•
enter a Destination Code (8 in this example)
set the Absorb Length to All
•
• the telephone that you are dialing out from must have
access to the PRI Pool (programmed in Terminals/Sets)
N0130943 02
Route
DialOut
Use
DN type
DestCode
Normal rte
Absorb
Dialing plans / 125
002
No numbr
Pool PRI-A
Public
9
002
ALL
Modular ICS 7.1 Installer Guide