Local System - Nortel ICS Install Manual

172 / Private networking using PRI SL-1
12. Repeat these steps for all the modes that are directly
adjacent to your system.

Local system

To set up the local system, you need to assign a target line to
the DN for the voice mail system, then enter that DN into the
target line record.
1. After you enter your password, at the Terminals&Sets
prompt, press ≠.
The prompt displays: Show set:
2. Enter the DN number for the Auto Attendant.
3. Press ≠. The prompt displays Line access.
4. Press ≠. The prompt displays Line
assignment.
5. Enter the target line number for the Auto Attendant
system.
6. Press CHANGE to change the setting for each line to one of
the following: Unassigned, Ring only, Appr&Ring, and
Appr only.
7. Press – until you reach the top level, then press
'. The prompt displays Lines.
8. Press ≠. The prompt displays Show line.
9. Enter the target line number you entered in step 5.
10. Press ≠. The prompt displays Line Type.
11. Press '. The prompt displays Rec'd #.
12. Enter the DN for the Auto Attendant system.
13. Exit programming.
Modular ICS 7.1 Installer Guide N0130943 02