Nortel ICS Install Manual page 500

500 / Hardware
To change the incoming call routing for a service, with the
display showing Protocol:, do the following:
1. Press ' until the display shows CbC Routing.
2. Press ≠. The display shows FX:.
3. Press NEXT to display a different service.
Note: The display shows the first applicable service for the
given protocol, in this example the service is FX.
4. Press CHANGE to change the mapping that is applied to
incoming calls of this service type to obtain the received
digits. In all cases, the received digits are used to find a
target line or to activate Remote Access.
None — No mapping is applied. The received number
length determines the number of digits of the Called Party
Number which will be used as received digits.
If there is no called party number, which may occur with
some FX calls, the call will ring at the incoming trunk
Prime set.
All — Allows you to define the received digits used for all
calls with this service type, regardless of the called party
number or service identifier (SID). For this option, all calls
with this service type on this PRI will ring the same target
line.
Map table — Allows you to associate different received
digits with different calls of this service type, depending
on the call party number and/or the service identifier.
Incoming calls that do not match any entry defined in the
map table will ring at the prime set. Depending on the
service type and the protocol, you may be able to map the
called party number and the service identifier.
Modular ICS 7.1 Installer Guide N0130943 02