Remote System - Nortel ICS Install Manual

168 / Private networking using PRI SL-1
7. Press – until you reach the top level, then press
'. The prompt displays Lines.
8. Press ≠. The prompt displays Show line.
9. Enter the target line number you entered in step 5.
10. Press ≠. The prompt displays Trunk/line data.
11. Press ≠. The prompt displays Line Type.
12. Press '. The prompt displays Rec'd #.
13. Enter the DN for the voice mail system.
14. Exit programming.

Remote system

On the nodes that are not directly connected to the central
voice mail system, you need to use the Telco Features
headings to identify the route to the voice mail system.
1. After you enter your password, press ' until the
prompt displays Telco Features:
2. Press ≠. The prompt displays VMsg Center
tel#s.
3. Press ≠. The prompt displays VMsg Center 1.
4. Press ≠. The prompt displays Use:.
5. Press CHANGE to until you reach Routing tbl.
6. Press '. The prompt displays Tel #:.
7. Enter the number to access the external voice mail system.
Modular ICS 7.1 Installer Guide N0130943 02