Access Codes; Line Pool Codes - Nortel ICS Install Manual

456 / System prgrming

Access codes

Access codes are used by the system to direct calls to the
correct lines and destinations. If the codes conflict, some of the
features on the system will not work.
The table of default settings can help you plan your access
codes so there are no conflicts.
Digits assigned by default to settings
Digit
0 direct-dial digit
1 Park prefix
2 the first digit of B1 DNs
line pool A access code
9
Takes precedence over the External Line
access code if there is a conflict.
— — external line access code
— — destination code

Line pool codes

This setting allows you to assign a line pool access code for
each of the 15 line pools (A to O). These codes are used to
specify the line pool you want to use for making an outgoing
external call.
If your system is installed without expansion cards, the DN
default is two digits. Therefore, B1 DNs will be from 21 to 52
and the B2 DNs are assigned from 53 to 84. The B2 DN range
is 80 to 84. Therefore, the single digit 8 is not available for a
line pool access code.
Use ≠, CHANGE, the dialpad, and OK to program the
access code.
Modular ICS 7.1 Installer Guide
Use
Installer password required
Heading
Access Codes
Access Codes
Startup
Access Codes
Access Codes
Routing Services
Installer password required
N0130943 02