Nortel ICS Install Manual page 650

650 / Glossary
is serviced by a remote voice mail
system from a third-party vendor, the
Meridian attendant telephone uses the
MIC/MCK buttons to activate the MWI
lamp on telephones at other sites.
Modular ICS NVRAM cartridge: A
replaceable cartridge containing the
Norstar features, commonly known as
the Feature cartridge. The ICS NVRAM
cartridge is inserted into the ICS.
Modular ICS ROM software
cartridge: A PCMCIA cartridge
containing the Norstar NA-MICS 4.0
features. The ICS ROM software
cartridge is inserted into the Modular
ICS NVRAM cartridge.
Module: A component of the Norstar
0X32 key system. Includes the
Integrated Communication System,
Trunk Module and Station Module.
Module status: A heading in
Maintenance programming that shows
what types of Trunk Cartridges are
connected and whether they're busy,
disabled, or malfunctioning.
Monitoring See Silent Monitoring.
Move Line buttons:
≤•°⁄
A feature that allows you to move
assigned lines to different buttons (with
indicators) on your telephone.
Music source: A radio or other
source of music can be connected to the
Integrated Communication System to
provide music for the Music on Hold
and Background Music features. A
music source is not part of the Norstar
system and must be supplied by the
customer.
Multiple least cost routing
(MLCR): This term refers to the ability
to define more than one route for a
destination code when schedules are
Modular ICS 7.1 Installer Guide
used. The system will attempt each
route in turn to find an available route
before routing the call to overflow.
N
Names: Names can be assigned to
System Speed Dial numbers, external
lines, telephones, and service schedules.
This is done in programming. You can
use up to 16 characters to name a
System Speed Dial number, and seven
characters to name a telephone, line, or
schedule. If a Name has not been
assigned, the line number or DN will
appear on the display instead of a name.
Network Call Diversion (NCD)
Norstar Network Call Diversion (NCD)
is a network function that allows
forwarding and redirection of calls
outside the Norstar network when using
an ETSI ISDN line. Functionality is
similar to that of External Call Forward
(ECF).
Network DN: A number supplied by
the ISDN network service provider for
ISDN terminal equipment.
Night schedule: See Schedules, and
Services.
NT1 (Network termination
type 1): A device used to connect the
U interface of a service provider and the
S or T interface (customer equipment).
The Modular ICS can act as an NT1
when equipped with a BRI-U2 or
BRI-U4 Card.
O
On hold: A setting, programmed
under Feature settings in Sys
prgrmmng, that controls whether
external callers hear music, periodic
tones, or silence when they are placed
on hold.
OPS: Off premise station.
OPX: Off premise set.
N0130943 02